Profax AEC 200 User Manual download pdf (Page 9)

CONTROL BOXES

For use in connecting the AEC 200 Welding Gun to a constant voltage welding power source.

WARNING

Disconnect all electrical power before installation

of this control unit. Touching live electrical

parts can cause fatal shock.

CAUTION

Shut off engine before attempting any installation.

Moving parts and live electrical connections

can maim.

AEC 200-1

TO INSTALL:

1.) Remove top cover from control unit.

2.) Install the multi-conductor cord from the AEC 200 Welding Gun through the access hole in the front panel of

the control box and connect the numbered wires to the corresponding numbers on the 8 pole terminal

strip TS1.

3.) Connect the contactor control cord on the back of the control box to the contactor control

receptacle on the welding power source. (See note below).

4.) Connect the 115 volt A.C. power cord from the control box to a 115 volt A.C. power source.

5.) Replace top cover and tighten screws.

NOTE

Terminals 1 and 2 on the four pole terminal strip TS2 are for use with welding power sources requiring a normally open set of

contacts for power source contactor operation. This set of contacts will close when the gun switch is operated.

Terminals 3 and 4 on the four pole terminal strip are for use with welding power sources requiring 115 VAC to be supplied to the

power source for contactor operation.

This control box comes with the contactor control cord connected to terminals 1 and 2.

CONSTANT VOLTAGE POWER SOURCE WITH 24 VOLT STRIP

CONSTANT VOLTAGE POWER SOURCE WITH AEC 200-1

MODEL AEC 200-1

115 VOLT AC

POWER CABLE

MODEL

AEC 200-1

CONTROL

115 VOLT AC

*PLUG NOT INCLUDED

MULTI CONDUCTOR

CABLE TO TERMINAL

STRIP IN CONTROL BOX

MODEL

AEC 200

SPOOL GUN

WORK

MODEL

AEC 200

SPOOL GUN

CABLE TO 24 VOLT

TERMINAL STRIP IN

POWER SUPPLY

POSITIVE

NEGATIVE

CABLE

BOOT

HOSE TO GAS

SUPPLY

GAS CYL.

POWER

SOURCE

CONNECTION

BLOCK

WELDING CABLE

TO WORK

GAS & WELDING

CABLE

WELDING CABLE FROM

NEGATIVE OUTPUT TERMINAL

ON POWER SOURCE

GAS & WELDING

CABLE

GAS

CYLINDER

HOSE TO GAS

SUPPLY

CONNECTION

BLOCK

CABLE

BOOT

WELDING CABLE TO

“GUN” STUD ASSEMBLY

ON CONTROL BOX

POWER

SOURCE

CONTACTOR CONTROL

CABLE TO CONTACTOR

CONTROL RECEPTACLE

ON POWER SOURCE

(see installation instructions)

POSITIVE

OUTPUT

TERMINAL

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Profax AEC 200 User Manual Page 9

Comments to this Manuals

Related products and manuals for Tools Profax AEC 200